Special Features of this Continuity Tester:
- Loud enough to hear it easily.
- Turns itself off after a reasonable time (approximately two minutes), but you can extend the time each time it beeps.
- Has ‘instant’ response.
- Has very low probe voltage (~200 mV).
- Defines continuity somewhere in the 25 ohm range.
- No programmable parts.
- All through hole parts (well, almost all).
Kit includes all that is needed to build and start testing.
Also includes the enclosure hole drilling template.
Read the article at the link below!
Build a Continuity Tester by Douglas Booth
